Effect of A Novel Atraumatic Rubber Dam Clamp on Cementoenamel Junction Surface Roughness: An in Vitro Experimental Study

Authors

  • Khushi Dua BDS
  • Manish Ranjan MDS

Keywords:

Sustainable dentistry; Oral health, Rubber dam clamp, Cemento-enamel junction, roughness.

Abstract

BACKGROUND: Rubber dam clamps provide essential tooth retention during operative procedures but establish a localized mechanical interface with the cervical tooth surface. Clamp material and geometry may influence surface alteration at the cementoenamel junction (CEJ), although comparative evidence involving atraumatic designs remains limited.

AIM: To compare changes in CEJ surface roughness following application of four rubber dam clamp designs for 30 minutes, 1 hour, and 2 hours.

METHODS: Seventy-two extracted human molars with intact cervical surfaces were randomly allocated to four clamp groups: NMD polymer, smooth stainless steel, serrated stainless steel, and a novel atraumatic polylactic acid (PLA) clamp. Six specimens from each group were evaluated at each application duration. Surface roughness (Ra) was measured using contact profilometry before and immediately after clamp application, with five standardized traces obtained per specimen. The primary outcome was percentage change in Ra. Within-group changes were assessed using paired comparisons, while differences among clamp groups at each duration were evaluated using the Kruskal-Wallis test followed by Dunn-Bonferroni post hoc analysis.

RESULTS: All 72 specimens completed the experimental protocol. The novel PLA clamp demonstrated the lowest mean percentage change in Ra at 30 minutes (2.81 ± 2.09%), 1 hour (2.50 ± 1.82%), and 2 hours (3.91 ± 2.71%). A significant between-group difference was identified at 1 hour (H = 8.940, P = .030; ε² = .297), with the only significant pairwise difference occurring between the serrated stainless-steel and novel PLA groups (adjusted P = .048). Between-group differences were not significant at 30 minutes (H = 6.040, P = .110) or 2 hours (H = 6.547, P = .088).

CONCLUSION: Clamp design was associated with CEJ surface roughness alteration at the 1-hour application period, whereas no significant between-group differences were detected at 30 minutes or 2 hours. The consistently lower numerical roughness change observed with the novel PLA clamp warrants further investigation using microscopic and mechanical analyses before its surface-protective performance can be established.

Published

2026-11-16

How to Cite

Dua BDS, K., & Ranjan MDS, M. (2026). Effect of A Novel Atraumatic Rubber Dam Clamp on Cementoenamel Junction Surface Roughness: An in Vitro Experimental Study. Adolescência E Saúde, 11–19. Retrieved from https://adolescenciaesaude.com/index.php/aes/article/view/3229

Issue

Section

Original Articles